At some of the kit car shows I’ve seen some great looking cars – look a little closer at the wiring and some look a little ropey. I am spending plenty of time in this area aiming to get the best standard of wiring possible for aesthetic reasons and efficiency.
Posts Tagged as ‘sports’
July 13, 2008
Final Exhaust parts
The left hand image shows the final elements of the exhaust, the can is a standard ZX12R can which is a challenge to fit but will work. A little more grinding is needed on the header welds and heat wrap will be used to keep the engine bay temperature down as much as possible.
May 24, 2008
Headers finished
Last two pics, on the left pipe no.3 I found the best way is to tape the pipe ends together but they do have to be tight to make it accurate. On the right no.4 job done!!
All told if I had my time again I would give it to somone else to do but I [...]
December 24, 2007
Sprocket and Hub
The top left of the picture is the new hub that replaces the sprocket – the nut and brass washer can be reused. Some thread lock will be needed when tightening and close attention to bending the brass washer over the nut will be required as about 160bhp + will be passing through it and [...]
